Trust the best-selling Official Cert Guide series from Cisco Press to help you learn, prepare, and practice for exam success. They are built with the objective of providing assessment, review, and practice to help ensure you are fully prepared for your certification exam.

It is part of a recommended learning path from Cisco that includes simulation and hands-on training from authorized Cisco 300-101 pdf Learning Partners and self-study products from Cisco Press. To find out more about instructor-led training, e-learning, and hands-on instruction offered by authorized Cisco Learning Partners worldwide.


The worldwide network landscape is continually changing with new technologies being introduced continually. The new revision of the Cisco ROUTE exam is the most information packed addition to the 300-101 Routing and Switching curriculum experienced to date!

By the time you’re done watching, you’ll be ready to configure routing protocols at a master level; grasp the big-picture of worldwide Cisco 300-101 vce network design; fill in plenty of “knowledge gaps” left by the 300-101 dumps on routing protocols; and confidently sit for the 300-101 exam.

A packet capture log indicates that several router solicitation messages were sent from a local host on the IPv6 segment. What is the expected acknowledgment and its usage?
A. Router acknowledgment messages will be forwarded upstream, where the DHCP server will allocate addresses to the local host.
B. Routers on the IPv6 segment will respond with an advertisement that provides an external path from the local subnet, as well as certain data, such as prefix discovery.
C. Duplicate Address Detection will determine if any other local host is using the same IPv6 address for communication with the IPv6 routers on the segment.
D. All local host traffic will be redirected to the router with the lowest ICMPv6 signature, which is statically defined by the network administrator.

Correct Answer: B Explanation

Explanation: Router Advertisements (RA) are sent in response to router solicitation messages. Router solicitation messages, which have a value of 133 in the Type field of the ICMP packet header, are sent by hosts at system startup so that the host can immediately autoconfigure without needing to wait for the next scheduled RA message. Given that router solicitation messages are usually sent by hosts at system startup (the host does not have a configured unicast address), the source address in router solicitation messages is usually the unspecified IPv6 address (0:0:0:0:0:0:0:0). If the host has a configured unicast address, the unicast address of the interface sending the router solicitation message is used as the source address in the message. The destination address in router solicitation messages is the all-routers multicast address with a scope of the link. When an RA is sent in response to a router solicitation, the destination address in the RA message is the unicast address of the source of the router solicitation message.

RA messages typically include the following information:
One or more onlink IPv6 prefixes that nodes on the local link can use to automatically configure their IPv6 addresses.
Lifetime information for each prefix included in the advertisement.
Sets of flags that indicate the type of autoconfiguration (stateless or stateful) that can be completed.
Default router information (whether the router sending the advertisement should be used as a default router and, if so, the amount exam of time (in seconds) the router should be used as a default router).


Read more: